Chassis

The content on this page was translated automatically.

If you can use a cordless screwdriver, wonderful. But everything can also be done with a "hand drill".

Pay particular attention to which holes are to be drilled with which drill bit, 2mm or 3mm.

If you only have a "normal" scroll saw available, then you may have to drill a few more holes in the corners of the cutout, because you then have to saw from two sides.

If possible, use a (large) protractor to mark out the model, it makes the whole thing easier.

If you want to make a steerable vehicle from your kit model, please take a look at the "Steering conversion drawing". (Instead of just one drive wheel, you should fit a wheel to the right and left of the engine mount. Bring the wheels as close as possible to the engine).

If you want to construct your own vehicle, then the "Drawing Alternative steering: Turntable" could contain a suggestion as to how you can build a rotating axle.

A tutorial on the conversion and photos of the turntable will follow...